Acclimate the module to the environment.
9.
Remove the pallet and any packaging materials from your work area.
10.
Install the Base Module
Installing the Base Module involves the following tasks:
Unpack the Base Module Accessory Kit
■
Install the Base Module Back Rails
■
Install the Base Module Front Rails
■
Mount the Base Module
■
Unpack the Base Module Accessory Kit
The base module accessory package should contain the following:
Back rails
■
10–32 clip nuts (used in racks with square holes)
■
Assorted screws:
■
–
–
–
–
Hex key (used to manually open a magazine)
■
Mounting block
■
Do not lift the Base Module by the front control panel, the
Note:
tape drive, or the tape drive filler.
If the module is colder than the location and sufficient
Note:
humidity exists, condensation may occur.
8–32 X 5/8 screws (used with the mounting block)
10–32 X 5/8 screws (used with clip nuts and racks with 10-32 threaded holes)
M5 0.8 X 16 mm screws (used with M5 threaded hole racks)
M6 16 mm screws (used with M6 threaded hole racks)
Install the Base Module
Installing the Library 2-5