Table of Contents
Advertisement
■
Click Next.
5.
Configure Network Interfaces Task 3: Configure Network Port 2 (optional)
With library code 3.50 and above, you can configure Network Port 2 for library
managed encryption (LME). Configuring Port 2 will force LME through Port 2 only.
Leaving the Port 2 configuration set to default will force LME through Port 1 only.
From the Network Port 2 list, select On or Off.
1.
For IPv4 select either: Static or DHCP (see
2.
Configure Network Port 1
The library supports Port 2 being on the same subnet as KMA IPv4 addresses.
Entering a gateway is not required if Port 2 and the KMA are on the same subnet.
You should enter a gateway that can reach all OKM cluster KMA's.
Click Next.
3.
Set the Library Date and Time
Run the Configuration
1.
Select the Time Zone and Closest City or Region from the drop-down lists. Click
2.
Next.
Either set the time Manually or use NTP:
3.
■
■
Click Next.
4.
Configure Library Settings
Run the Configuration
1.
Select the Drive Element Addressing Mode. The correct setting for your system
2.
depends on your current configuration (for help deciding on a mode, see
"Selecting a Drive Element Addressing Mode"
network interface card in the robot/controller assembly. A stateless address
will not change unless the robot has to be replaced
DHCPv6 — If a DHCPv6 server is available on your network, you can select
DHCPv6. Be aware the network address of the library user interface will
change.
Do not configure Port 2 for any other use than with
IMPORTANT:
LME, otherwise you may encounter issues. If you are not using LME,
Oracle recommends that you leave Port 2 set to the defaults. See
"Behavior of Port 1 and Port 2"
for a description of these options).
You should configure Port 2 to be on a different network than
Note:
Port 1 to create a secure and private connection to pass the encryption
keys between the library and the OKM cluster.
Wizard. Select Set the Library Date and Time.
Manually — Enter the date using the format mm/dd/yyyy (month/day/year).
Enter the time using the format hh:mm:ss (hour:minute:seconds).
Network Time Protocol — Enter the addresses of up to three NTP servers.
Wizard. Select Configure Library Settings.
Set the Time, Network Address, Library Settings, and Encryption
on page 1-4 for more information.
Configure Network Interfaces Task 2:
on page 4-4).
Configuring the Library 4-3
Advertisement
Table of Contents
