Set the Time, Network Address, Library Settings, and Encryption
Click OK. Reassign resources as needed (see
3.
Resources to the Partition
Otherwise, if you are finished, review and apply the configuration changes.
4.
Partition the Library Task 4: Verify the Partitioning Configuration Changes
Once you are finished partitioning, review your changes and then click Next.
Configure Library Managed Encryption (LME)
The library can manage the encryption enrollment and key delivery of all IBM LTO-7
or higher drives. For HP LTO-6 drives and earlier, you must still use the Virtual Op
Panel (VOP) software to enroll the drives.
Configure LME Task 1: Obtain Information from OKM
■
Configure LME Task 2: Configure the SL150 to Manage Encryption
■
Configure LME Task 3: Verify the SL150 Agent is Enrolled
■
Configure LME Task 1: Obtain Information from OKM
Have the OKM administrator use the OKM GUI to create an SL150 library agent and
then record the following information to use in the SL150 configuration:
Agent Name
■
Passphrase
■
Configure LME Task 2: Configure the SL150 to Manage Encryption
In the SL150 GUI,
1.
Encryption.
Set "Library Encryption Status" to Encrypting.
2.
This globally enables library managed encryption for all IBM LTO-7+ drives
within the library regardless of the partitioning configuration.
Enter the following information:
3.
■
■
■
Note the port that will be used for OKM communication.
4.
If you altered the Port 2 configuration, all LME traffic will go through Port 2. If
you left the Port 2 configuration set to default values, LME traffic will go through
Port 1.
Leave the OKM tuning parameters at their default setting unless instructed to
5.
change them by your OKM administrator.
4-6 StorageTek SL150 Modular Tape Library Guide
above).
Library encryption must be configured separately and
IMPORTANT:
after all other library configuration options. Make sure you have
completed the network configuration and completed a library reboot
before configuring encryption. If not, see
Interfaces"
on page 4-2.
Run the Configuration
OKM Cluster IP address
Agent ID
Agent Passphrase
Partition the Library Task 2: Assign
"Configure the Network
Wizard. Select Configure Library