Install Clip Nuts For The Expansion Module (For Square Hole Racks Only); Library Floor Removal From The Base Module - StorageTek SL150 Manual

Install the Expansion Module
Figure 2–13 Library Floor Removal from the Base Module
Illustration Legend:
1 - Floor Finger Holds
2 - Floor Lock (Improved Floor Design)

Install Clip Nuts for the Expansion Module (for square hole racks only)

Locate the middle hole of the second U (fifth hole down from the junction of the
1.
first U boundary) on both the left and right rail stiles (see
installation of the clip nut. Use the Rail Installation Template, if desired.
For each clip nut location:
2.
a.
b.
Make sure the clip nuts are parallel (in the identical mounting hole).
3.
Locate the 2U space at the back of the rack directly below the installed module.
4.
Insert a clip nut in the third hole down from the junction of the first U boundary
5.
on both the left and right rail stiles.
Make sure the clip nuts are parallel (in the identical mounting hole).
6.
2-16 StorageTek SL150 Modular Tape Library Guide
If the rack has threaded holes, skip to
Note:
Expansion Module by Removing the Cartridge Magazines"
page 2-17.
Seat one edge of the clip nut into the hole from the back of the rack stile.
Compress the other edge of the clip nut and seat it in the hole.
"Prepare the
on
Figure 2–14) for