Install the Expansion Module
Figure 2–15
Illustration Legend:
1 - Module Flanges
2 - Unlatched Position
3 - Latched Position
Install the Floor in the Bottom Expansion Module
Turn the module over.
1.
Orient the floor so the finger holds are facing the inside of the cartridge magazine
2.
slot (see
Insert the rear edge of the floor into the grooves at the bottom of the module.
3.
Push the floor in and engage the rear floor tab with the module slot (see
4.
Figure
Push the floor in and seat the floor clip in each magazine bay (see
5.
Turn the module over and verify the floor clips properly engage the chassis.
6.
2-18 StorageTek SL150 Modular Tape Library Guide
Magazine Latches
IMPORTANT:
Only perform this procedure for the bottom module.
Figure
2–13).
2–16).
Figure
2–17).