Secure The Expansion Module To The Front Rack Stile; Replace The Cartridge Magazines; Label The Modules - StorageTek SL150 Manual

Install the Expansion Module
Repeat this task for the rail on the other side of the module.
5.

Secure the Expansion Module to the Front Rack Stile

Insert a screw in the lower left side of the module and thread it a few turns.
1.
Insert a screw in the lower right side of the module and thread it a few turns.
2.
Fully tighten both screws.
3.
Install another expansion module (see
4.
Kit").

Replace the Cartridge Magazines

Orient the magazine with the cartridge slots facing toward the center of the
1.
module.
Lift the magazine and point the back toward the module slot.
2.
Engage the magazine with the track in the magazine slot.
3.
Push the magazine fully into the slot.
4.
Repeat as necessary until each expansion modules has two magazines.
5.

Label the Modules

Locate the scribe lines in the upper left corner of the expansion module (as viewed
1.
from the back of the rack).
Obtain the module label sheet from the accessory kit.
2.
Peel the proper label from the label sheet.
3.
Orient the label properly, align the label with the scribe lines, and adhere the label
4.
to the chassis (see
2-22 StorageTek SL150 Modular Tape Library Guide
Use a 10-32 screw when a rack has square holes (the screw
Tip:
mates with a clip nut).
Left and right magazines are unique.
Note:
Note: Do not put cartridges in the magazine slots.
The sheet has labels for Module 2 through Module 10.
Note:
Figure 2–21).
"Unpack the Expansion Module Accessory