Table of Contents
Advertisement
Remove the replacement front control panel from its packaging.
1.
Grasp the panel by the plastic housing and raise it to the base module.
2.
Attach the cable to the circuit card jack at the back of the panel. Make sure the
3.
connector is flush with the jack.
Insert the tabs on the top edge of the panel into the base module slots (see image
4.
below for slot locations).
Rotate the front control panel down and press the bottom edge into the base
5.
module slots. The panel snaps in place.
Replace both cartridge magazines. Lock the magazines and audit the library (see
6.
"Load the Magazines Task 4: Locking the Magazines and Auditing the Library"
page 6-9).
Power-cycle the library. Follow the power on procedures (see
7.
Component Installation"
Module Controller Removal and Replacement
The module controller is located in the upper right corner of the expansion module as
viewed from the rear of the library (see
controller obtains power from the expansion cable connected to a Module Output port
on the base module.
Remove the Module Controller
■
Replace the Module Controller
■
Remove the Module Controller
Power down the library (see
1.
Disconnect the expansion cable plug from the input port on the module controller.
2.
on page 10-19).
Note:
Be aware of ESD (see
Module Controller Removal and Replacement
"CRU Locations"
on page 10-1). The module
"Electrostatic Discharge"
"Power Off the Library"
Replacing Components (CRUs & FRUs) 10-7
"Validate the
on page 2-3).
on page 9-2).
on
Advertisement
Table of Contents
