Table of Contents
Advertisement
Figure 2–12 Expansion Module Accessory Package Hardware
Illustration Legend:
1 - Back Rails
2 - Clip Nuts
3 - Screws (Assorted)
4 - Expansion Cable with USB Type A Connectors
5 - Module Labels
6 - Hook and Loop Strap
7 - Rivet
8 - Hex Key
Remove the Library Floor
If you are upgrading an existing library, power down the library (see
1.
the Library"
skip to the next step.
Remove the cartridge magazines from the bottom module of the library (see
2.
"Mount the Base Module Task 2: Remove the Cartridge Magazine with the Hex
Key"
Grasp the holds on the front edge of the floor in the magazine bay (see figure
3.
below).
Pull the floor out the front of the module, and set it aside.
4.
on page 9-2) and verify that you have locked the robot. Otherwise,
on page 2-12).
If the floor does not move, reach through the magazine
Note:
opening and push down on the floor behind the touch screen panel to
unseat the floor locking tabs. Then pull the floor forward.
Install the Expansion Module
"Power Off
Installing the Library 2-15
Advertisement
Table of Contents
