Table of Contents
Advertisement
Figure 10–7 Base Module FRU
If the library has expansion modules, remove all of the expansion modules to access
the defective base module.
Remove the Base Module Chassis
Remove Base Task 1: Lock the Robot and Remove Expansion Modules
■
Remove Base Task 2: Remove Module and Remove Parts for Reuse
■
Remove Base Task 1: Lock the Robot and Remove Expansion Modules
Park and lock the robot (see
1.
on page 10-9).
Remove all modules below the base module (see
2.
on page 10-13).
Remove Base Task 2: Remove Module and Remove Parts for Reuse
Remove the following applicable parts from the Base module:
1.
■
■
■
■
■
■
■
Remove the screws securing the base module to the front of the rack.
2.
The robot, front control panel, and base module chassis are
Caution:
critical to maintaining the product serial number and customer
settings. When a replacement is needed, you may replace only one
unique device during a single power-down cycle.
"Load the Magazines Task 1: Unlock and Remove the Magazines"
"Remove the Drive Tray"
"Remove a Drive Filler"
"Remove the Power Supply"
"Remove a Power Supply Filler"
"Remove the Front Control Panel"
"Remove the Robot"
on page 10-9
Base Module (Module 1) Chassis Removal and Replacement
"Remove the Robot Task 1: Park and Lock the Robot"
"Remove an Expansion Module"
on page 10-2
on page 10-4
on page 10-4
on page 10-5
on page 10-6
Replacing Components (CRUs & FRUs) 10-17
on page 6-7
Advertisement
Table of Contents
