Module; Remove Expansion Task 4: Remove Components From The Defective Module; Replace The Expansion Fru Chassis; Replace Expansion Task 1: Install The Chassis - StorageTek SL150 Manual

Figure 10–6 Module Rear Rail Removal
Illustration Legend:
1 - Rear Rail
2 - Clip Nut

Remove Expansion Task 4: Remove Components from the Defective Module

Remove the functional components as applicable:
1.
■
■
■
■
■
Remove the failed expansion module.
2.

Replace the Expansion FRU Chassis

Replace Expansion Task 1: Install the Chassis

■
Replace Expansion Task 2: Install CRUs, Fillers, and Magazines in Replaced
■

Module

Replace Expansion Task 3: Install the Remaining Expansion Modules
■
Replace Expansion Task 4: Finishing Touches
■
Replace Expansion Task 1: Install the Chassis
Grasp the expansion module chassis by the sides and remove it from the shipping
1.
carton.
Remove the magazines from the expansion module (see
2.
Module by Removing the Cartridge Magazines"
If this will be the bottom module of the library, install the library floor now (see
3.
"Install the Floor in the Bottom Expansion Module"
Mount the module (see
4.
Install the rails (see
5.
page 2-21).
"Remove the Drive Tray"
"Remove a Drive Filler"
"Remove the Power Supply"
"Remove a Power Supply Filler"
"Remove the Module Controller"
"Mount the Expansion Module"
"Install the Rear Rails for the Expansion Module"
Expansion Module Chassis Removal and Replacement (FRU)
on page 10-2
on page 10-4
on page 10-4
on page 10-5
on page 10-7
on page 2-17).
on page 2-18).
Replacing Components (CRUs & FRUs) 10-15
"Prepare the Expansion
on page 2-19).
on