Power Supply Removal and Replacement
Remove a Drive Filler
You may need to remove a drive filler, if you are installing a new drive tray or need to
gain access to the library. See
Install a Drive Filler
Position the tape drive filler with the spring fingers facing up.
1.
Grasp the captive screws and guide the filler into the tape drive slot.
2.
Tighten both thumbscrews.
3.
Power Supply Removal and Replacement
Remove the Power Supply
■
Replace the Power Supply
■
Remove a Power Supply Filler
■
Install a Power Supply Filler
■
Figure 10–2 Power Supply CRU
Illustration Legend:
1 - Power Supply Indicators
2 - Power Supply Latch
Remove the Power Supply
If the library only has one power supply, power off the library before proceeding
1.
(see
Disconnect the power cord from the defective power supply.
2.
Press the latch towards the left (toward the fan) to release the power supply.
3.
Grasp the power supply by the handle, pull it out of the library, and set it aside.
4.
Replace the Power Supply
Remove the power supply from the shipping carton.
1.
Grasp the supply by the handle and support the bottom with your other hand.
2.
Orient the power supply as shown in
3.
10-4 StorageTek SL150 Modular Tape Library Guide
"Remove a Tape Drive Filler"
"Power Off the Library"
on page 9-2).
Figure 10–2
(oriented with LEDs on left).
on page 2-26