Table of Contents
Advertisement
Apply Power to the Library
Rotate the lock clockwise 180 degrees, and slide the long tab into the slot at right.
2.
Verify that the white unlocked padlock icon is visible in the small window.
Secure the lock assembly by tightening the captive screw.
3.
Apply Power to the Library
Make sure the robot is unlocked.
1.
Press the power button on the front panel of the base module.
2.
The time duration of the startup varies based the size of the library. See the
"Library Startup Sequence"
startup.
Configure the Library After Powering-on for the First Time
Use the front touch screen to perform initial library configuration.
Configure the Library: Login with the Default Admin
■
Configure the Library Step 1 of 6: Change the Default Administrator Password
■
Configure the Library Step 2 of 6: Configure the Network Port 1
■
Configure the Library Step 3 of 6: Set the Library Date and Time
■
Configure the Library Step 4 of 6: Set the Drive Element Addressing Mode)
■
Configure the Library Step 5 of 6: Configure the Mailslot, Reserved Slots and
■
Volume Label Format
Configure the Library Step 6 of 6: Review and Apply Initialization Settings
■
Configure the Library: Finish the New Configuration
■
Configure the Library: Login with the Default Admin
After powering on the library for the first time, tap Start.
1.
2-30 StorageTek SL150 Modular Tape Library Guide
on page 9-2 for what the library does during the
Note:
Do not manually remove a cartridge magazine while the
library is performing a restart. Only perform a manual cartridge
magazine removal when the library is operational and offline.
The Initialization Wizard in code versions before 2.0 did not
Note:
include setting the drive element addressing mode or configuring the
mailslots.
Advertisement
Table of Contents
