Table of Contents
Advertisement
10.12 Robot mounting/dismounting
Robot weight
The weight for some example robots is shown below. The weight of other robots
can be found in the robot manual.
Specification of bolts and washers
The required bolts for some example robots are shown below. Data for other robots
can be found in the robot manual.
Tightening torque 200 Nm
How to mount or dismount a robot to FlexLoader SC 6000
Mount the robot to FlexLoader SC 6000 by the following procedure
For dismounting the robot, follow the steps above in reverse order.
Robot fine calibration
When fine-calibrating the robot, it must be on flat level surface. Thus it must be
dismounted from the FlexLoader SC 6000.
Product manual - FlexLoader SC 6000
3HAC051768-001 Revision: D
•
4600, 60kg, 2.05m: 425 kg
•
2600, 20kg, 1.65m: 272 kg
•
ABB 4600: 6 bolts M16 x 60, 6 washers 17 x 30 x 3, quality 8.8
•
ABB 2600: 3 bolts M16 x 60, 3 washers 17 x 30 x 3, quality 8.8
DANGER
Avoid dangerous robot swing movements by carefully taking into account the
center of mass of the hanging robot.
•
Use a fork lift and place the pallet with the robot as close as possible to the
FlexLoader SC 6000 robot pedestal.
•
Attach straps to robot.
•
Attach the straps to a forklift with enough handling weight to handle the
robots weight.
•
Place the robot at the FlexLoader SC 6000 robot pedestal.
•
Secure the robot by mounting the M16 bolts, tightening torque 200 Nm.
•
Mount electric and pneumatic connections to the robot.
© Copyright 2014-2020 ABB. All rights reserved.
10.12 Robot mounting/dismounting
10 Repair
163
Advertisement
Table of Contents
