Table of Contents
Advertisement
4.3 Vision system FlexLoader Vision
FlexLoader SC 6000 is delivered with FlexLoader Vision pre-installed and
pre-configured on the FlexLoader Vision PC.
Refer to the FlexLoader Vision manual for detailed information on teachin,
configuration and problem solving etc.
Product manual - FlexLoader SC 6000
3HAC051768-001 Revision: D
Tip
Apart from Windows security updates, do not install any updates or patches if
not advised from ABB or ABB:s subsupplier.
•
Visually check that all parts of the lighting system are working. If not, replace
illumination according to the maintenance section.
•
Visually check the camera image for any signs of misalignment, blurring, dirt
etc. If necessary, take appropriate actions, e.g. realignment, adjusting focus
or lens cleaning, according to the maintenance section.
-
Adjust focus: Place a sheet of paper with text or information below the
camera on the belt. If you intend to run FlexLoader SC 6000 with tall
details, put the sheet on an appropriate height. Adjust the lens focus
ring and lock it.
For additional help, use the focus value in the large view. Normally, a
higher value indicates a better focus.
-
Adjust the lens aperture: Set the exposure time in FlexLoader Vision
to ~20% of the maximum value. Adjust the contrast to ~50% of the
slider maximum. Place appropriate details on the belt and adjust the
lens aperture ring in order to obtain a reasonable image. Lock the
aperture ring.
Note
Keep in mind that the FlexLoader Vision PC has limited system resources for
non-vision related tasks. Do not strain the memory or the hard disk space.
Tip
Immediately after initial commissioning, start maintaining your own system
backups.
Tip
If you for some reason would lose the pre-installation and pre-configuration data
of the FlexLoader Vision system, you can find a primary backup. See
on page 164
for detailed information.
© Copyright 2014-2020 ABB. All rights reserved.
4 Commissioning
4.3 Vision system FlexLoader Vision
Software
59
Advertisement
Table of Contents
