Marking Unit - ABB FlexLoader SC 6000 Product Manual

4 Commissioning

4.7 Marking unit

4.7 Marking unit
General
The marking unit is a standard FlexLoader SC 6000 option. The hardware consists
of a SIC marking equipment, i.e. an i53 marking head with an E10 controller unit.
During operation, the robot communicates by means of serial communication with
the controller unit. The robot must thus be equipped with the serial communication
option (970-1).
For in-depth information refer to the section on pre-configuration data.
Configuration changes
The controller unit is pre-configured for use with the FlexLoader SC 6000.
Configuration changes can be done by using the SIC controller configuration
software (delivered on the FlexLoader Vision storage, to be installed on a separate
PC, communication with standard USB cable).
Typical changes might be modifications of the marking setup files. FlexLoader SC
6000 is using three different marking files for different sizes: SMALL, MEDIUM,
LARGE.
For in-depth information refer to the section on pre-configuration data, especially
if you intend to modify the marking units configuration.
76
© Copyright 2014-2020 ABB. All rights reserved.
Product manual - FlexLoader SC 6000
3HAC051768-001 Revision: D