Table of Contents
Advertisement
10 Repair
10.11 Marking unit
10.11 Marking unit
Exchange of marking unit
The marking unit can be exchanged by the following procedure:
162
•
Disconnect the electrical contact by turning it anticlockwise
•
Unscrew the four M6 screws holding the marking unit
•
Replace with a new marking unit in reverse order.
CAUTION
If there are any changes in position/design between the new and old unit the
robot positions need to be updated.
CAUTION
Run system at slow speed for the first cycles to ensure the air cleaning box is
in correct position.
© Copyright 2014-2020 ABB. All rights reserved.
Product manual - FlexLoader SC 6000
3HAC051768-001 Revision: D
Advertisement
Table of Contents
