Table of Contents
Advertisement
2.3 Safety during setup, maintenance, service and repair
Always ensure that FlexLoader SC 6000 cannot be started when working on the
cell. The installed protection that belongs to the equipment must always remain
installed during automatic operation.
Work on mechanical systems must only be carried out by qualified person or by
a trained person under guidance and supervision of a qualified person according
to the applicable technical regulations.
Work on electrical systems or operating material must only be carried out by a
qualified electrician or by a trained person under guidance and supervision of a
qualified electrician according to the applicable electrical technical regulations.
The following must be performed before performing work on FlexLoader SC 6000:
Note that mechanical, pneumatic or electrical energy may be stored in FlexLoader
SC 6000. Take the necessary precautions when carrying out work in the robot cell.
All safety and warning signs must be kept clean and legible. If necessary, replace
them.
Always check the function of all safety devices after performing work that may
have had an impact on the safety systems.
Product manual - FlexLoader SC 6000
3HAC051768-001 Revision: D
2.3 Safety during setup, maintenance, service and repair
•
Emergency stop must be activated (FlexLoader SC 6000 not in operation).
•
The voltage supply to the robot cell must be disconnected.
•
Action must be taken so that the voltage supply to the robot cell cannot be
connected when work is carried out on the conveyor belt. Use the available
lockout device.
•
The air supply must be disconnected. Use the available lockout device.
•
The key for resetting the protective stop must be carried when working within
the safeguarded area of FlexLoader SC 6000.
CAUTION
Ear and eye protection shall be used when working with an air cleaning
box/deburring unit. The need will depend on the application and shall be risk
assessed.
CAUTION
Ear and eye protection shall be used when working with an air nozzle on the
gripper system.
CAUTION
Protective shoes shall be used when working with the FlexLoader SC 6000. The
need will depend on the application and shall be risk assessed.
© Copyright 2014-2020 ABB. All rights reserved.
2 Safety
Continues on next page
15
Advertisement
Table of Contents
