Change Command Injection Port Number; Enable/Disable Output Signal Modulation; Sending Message Via The Communication Ports; Sendingatcpmessage(Ascii-Format)Viatcpport - Lightware HDMI-TPS-RX110AY Series User Manual


  
7.LW3Programmers'Reference
7.11.2. Change Command Injection Port Number
Command and Response
SET·/MEDIA/IR/<in|out>.CommandInjectionPort=<port_no>
Î
pw·/MEDIA/IR/<in|out>.CommandInjectionPort=<port_no>
Í
Example
Î SET/MEDIA/IR/S1.CommandInjectionPort=9001
Í pw/MEDIA/IR/S1.CommandInjectionPort=9001
7.11.3. Enable/Disable Output Signal Modulation
Command and Response
SET·/MEDIA/IR/<out>.EnableModulation=<logical_value>
Î
pw·/MEDIA/IR/<out>.EnableModulation=<logical_value>
Í
Parameters
Identifier Parameter description
Signalmodulationenable/
<logical_value>
disable setting
Example
Î SET/MEDIA/IR/D1.EnableModulation=false
Í pw/MEDIA/IR/D1.EnableModulation=false
Signal modulation is turned off on IR output (D1).
INFO:
The default setting value is true (enabled).
HDMI-TPS-RX110AY series – User's Manual
Value Explanation
true The signal modulation is enabled.
false The signal modulation is disabled.
Appliedfirmwarepackage:v1.4.0 | LDCsoftware:v2.4.0b3
7.12. Sending Message via the Communication Ports
7.12.1. Sending a TCP Message (ASCII-format) via TCP Port
The command is for sending a command message in ASCII-format. This method allows escaping the control
characters. For more information see the Escaping
Command and Response #message
Î CALL·/MEDIA/ETHERNET:tcpMessage(<IP_address>:<port_no>=<message>)
Í mO·/MEDIA/ETHERNET:tcpMessage
Example
Î CALL/MEDIA/ETHERNET:tcpMessage(192.168.0.103:6107=C00)
Í mO/MEDIA/ETHERNET:tcpMessage
The'C00'messageissenttotheindicatedIP:portaddress.
Example with HEX codes
Î CALL/MEDIA/ETHERNET:tcpMessage(192.168.0.20:5555=C00\x0a\x0d)
Í mO/MEDIA/ETHERNET:tcpMessage
The'C00'messagewithCrLf(CarriagereturnandLinefeed)issenttotheindicatedIP:portaddress.The
\xsequenceindicatestheHEXAcode;seemoreinformationintheUsing Hexadecimal Codes
7.12.2. Sending a TCP Text (ASCII-format) via TCP Port
The command is for sending a text message in ASCII-format. This method does not allow sending message
with control and non-printable characters.
Command and Response
Î CALL·/MEDIA/ETHERNET:tcpText(<IP_address>:<port_no>=<text>)
Í mO·/MEDIA/ETHERNET:tcpText
Example
Î CALL/MEDIA/ETHERNET:tcpText(192.168.0.103:6107=pwr_on)
Í mO/MEDIA/ETHERNET:tcpText
Explanation
The'pwr_on'textissenttotheindicatedIP:portaddress.
section.
section.
85