Selecting The Color Correction Mode; Correcting For Ambient Light; Setting The Frame Delay; Enabling Film Mode Detect - Christie Mirage SST-6P User Manual

Selecting the color correction mode

Select the color correction mode most suited to the input signal.
1. Select MENU > Image Settings > Color & Gamma > Color Correction Mode.
2. Select the adjustment most suited to the input signal:
• Auto Detect—Automatically detect the appropriate color correction mode, where possible.
• Max Drives—All color adjustments are turned off, allowing the projector to run at
maximum brightness.
• Color Temperature—Specify a color temperature between 3200 and 9300, expressed in
degrees Kelvin.
• HD Video—Set the output color to a specific standard value. Adjusts the colors red,
green, blue, and white.
• DCI P3—Set the DCI P3 (cinema) colorimetry with DCI white point.
• DCI P3 (D65)—Set the DCI P3 colorimetry with D65 white point.
• Custom—Select a user defined set of color adjustments.
3. Select Enter.

Correcting for ambient light

Ambient light is the natural light that occurs in the environment where the projector is located.
1. Select MENU > Image Settings > Color & Gamma > Ambient Light Correction.
2. Select Enter.
3. Use the right and left arrows to adjust how the image displays in conditions with ambient light.
4. To confirm your selection, select Enter.

Setting the frame delay

Delay the output signal timing relative to the input signal timing by a fraction of a frame, and up to
several frames.
The minimum latency can vary based on the amount of scaling applied to the image. When using
keystone or warping, an additional latency is required, depending on the amount of warp.
1. Select MENU > Image Settings > Advanced Image Settings > Frame Delay.
2. To set the total video frame delay, select Set Delay.
3. Adjust the value and to confirm your selection, select Enter.
The Actual Delay field reports what the system has delivered for the frame delay. The value is reported
in frames and milliseconds.

Enabling film mode detect

Enables or disables the detection of film motion.
1. Select MENU > Image Settings > Advanced Image Settings > Film Mode Detect.
Mirage SST User Guide
020-102993-06 Rev. 1 (10-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Adjusting the image
30