Setting The Frame Delay; Enabling Film Mode Detect; Adjusting The Image Sharpness; Creating A Seamless Image With Edge Blending - Christie Mirage 304K User Manual

Setting the frame delay

Delay the output signal timing relative to the input signal timing by a fraction of a frame, and up to
several frames.
The minimum latency can vary based on the amount of scaling applied to the image. When using
keystone or warping, an additional latency is required, depending on the amount of warp.
1. Select MENU > Image Settings > Advanced Image Settings > Frame Delay.
You can also set the frame delay from the 3D Settings menu.
2. To set the frame delay, select Set Delay.
3. Adjust the value and to confirm your selection, select Enter.
4. To set the achievable frame delay, select Actual Delay.
5. Adjust the value and to confirm your selection, select Enter.

Enabling film mode detect

Enables or disables the detection of film motion.
1. Select MENU > Image Settings > Advanced Image Settings > Film Mode Detect.
2. To enable the detection of film motion, select Auto Detect.
3. To disable the detection of film motion, select Disabled.
4. Select Enter.

Adjusting the image sharpness

Change the sharpness of the image.
Lower settings can improve a noisy signal. Setting the sharpness above the halfway point can
introduce noise in the image.
1. Select MENU > Image Settings > Advanced Image Settings > Sharpness.
2. Select Enter.
3. Use the right and left arrows to adjust the sharpness of the image.
4. To confirm your selection, select Enter.

Creating a seamless image with edge blending

Combine several projected images into one single, seamless image with edge blending.

Adding edge blends to the projector

Use Christie or to create edge blends and upload them to Mirage 304K.
1. Create an edge blend file using the Christie or application.
To connect Mirage 304K with Christie or , use port 3003.
Mirage 304K (Bm.1) User Guide
020-101778-12 Rev. 1 (04-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Adjusting the image
30