Network Configuration - Christie DHD800 User Manual

Network set-up & operation

Hide thumbs Also See for DHD800:

Table of Contents

Network configuration

Set the Wired LAN network through the projector menu. Detailed network settings will be

made with browser. Refer to "3. Basic setting and operation" (p.17-30). First, complete the

settings described in this chapter before performing steps in "3. Basic setting and opera-

tion."

Setting Procedure

1. Select Network icon in the menu bar with the Point

button once.

2. Make sure that the Network mode is set to "On". If the mode is "Off", switch to ON with

the Point

buttons. Then the Menu will disappear, the "Please wait..." message will

appear, and switching operation will start. Switching will take a while and the projector's

LINK/ACT Lamp will be on or blink, and after completing the operation, the "Please

wait..." message will disappear.

Side Terminals

LAN Connection Terminal

DHD800 Network User Manual

020-000246-01 Rev.1 (08-2010)

Switches between on and off

with the Point

buttons.

buttons, and press SELECT

Network icon

LINK Lamp (Green)

Light green when the

projector is connected to

the network correctly.

ACT Lamp (Orange)

Blink orange when the

projector is sending or

receiving the data.

Network configuration

Table of Contents