Arrayloc Network Configuration - Christie Mirage WQ-L User Manual

2. Connect an RS232 serial cable between the RS232 OUT connector of the first projector and the
RS232 IN connector of the next projector. Connect the remaining projectors using RS232
cables.
3. Set the serial options in Configuration > Communications. See
50.
4. Set network routing in Configuration > Communications > Network Routing to RS232
and RS422 Joined. See

ArrayLOC Network Configuration

Preliminary color setup is managed by ArrayLOC. ArrayLOC is enabled by default and configured to
display a reasonably saturated gamut at the maximum brightness that all the projectors in the
array can support. See
A projector that is not connected via ArrayLOC functions as a single unit array.
ArrayLOC over Control Network
Use the Control Network for ArrayLOC when you want to communicate with the projectors in the
array over the same network.
1. Connect the controller by connecting a CAT5 Ethernet cable between the PC and the ArrayLOC
network switch.
2. Connect a standard CAT5 Ethernet cable between the ArrayLOC network switch and the Control
Network port of each projector.
3. From the Main menu, select ArrayLOC > ArrayLOC Configuration.
4. From the ArrayLOC Network drop-down list select Control Network.
Mirage WQ-L User Manual
020-101372-01 Rev. 1 (04-2014)
Network Routing
RS232 OUT
RS232 IN
RS422
Configure the Display
on page 50.
RS232 OUT
RS232 IN
on page 48 for detailed information.
Installation
Communications on page
RS232 IN
25