Arrayloc Over Phm Network; Calculate Your Hardware Requirement; Phm Network Example: 2 X 3 Wall - Christie Entero RPMSP–LED01 Installation Manual

3.7.2 ArrayLOC Over PHM Network

In a PHM Network for ArrayLOC, only the PHM of each projector is
connected to the network switch. The projector EM remains connected to
the PHM.

Calculate Your Hardware Requirement

In an PHM Network for ArrayLOC, each projector requires 1 port on a
network switch. For example, if you install a 2 x 4 cube wall with 8
projectors, 8 ports are required (8 x 1 = 8).
If you use multiple switches, they must be connected to one another to
form a single network. Typically, 2 extra ports are required on each
switch when you install multiple switches. For example, 14 ports are
required if you install 3 switches for a 2 x 4 cube wall with 8 projectors (8
x 1 = 8) + (2 x 3 = 6) = 14.

PHM Network Example: 2 x 3 Wall

This illustration shows a 2 x 3 wall with a single 6–port switch.
EM
EM
3-14
EM
PHM LM
Adjuster
EM
PHM LM
Adjuster
ArrayLOC Network
EM
PHM LM
Adjuster
EM
PHM LM
Adjuster
Switch
Entero Projector and Cube Installation Manual
PHM LM
Adjuster
PHM LM
Adjuster
020-100839-01 Rev. 2 (04-2013)