Network Setup For External Communications - Christie Mirage WQ-L User Manual

2. After the internal cooling fans stop, flip the main power switch to the Off position.
3. Disconnect the line cord from the wall outlet.

Network Setup for External Communications

To complete the projector network setup you will also need to connect the projectors
together for ArrayLOC communication and functions. See
on page 25.
Ethernet (recommended)
In the Ethernet network the controller communicates with each projector separately.
Recommended for network administrators only.
1. Connect a standard CAT5 Ethernet cable between the controller (or Ethernet hub) and the
Control Network port on the projectors input panel.
2. From the WebUI, set the IP address in Configuration > Communications > Ethernet
Settings. See
3. From the WebUI, in Configuration > Communications set network routing to Separate. See
Communications
Mirage WQ-L User Manual
020-101372-01 Rev. 1 (04-2014)
CAT5
CAT5
to other
Ethernet devices
Communications on page 50.
on page 50.
ArrayLOC Network Configuration
CAT5
CAT5
Installation
22