Net-Network Setup - Christie Boxer 4K Technical Reference

Commands
Command Description
LVO <position> Adjusts the vertical location of the lens to
the specified position. This position is
persistent across AC cycles. (Saved value)
LVO?m Returns the minimum and maximum range
of the vertical axis based on the last lens
calibration performed. The returned range is
persistent across AC cycles. (Read-only)
Examples
Move the lens to position 500 on the vertical axis:
(LVO 500)
NET–Network Setup
Modifies the network setup for this device.
By default, DHCP support is turned on.
Commands
Command
NET <ip> <subnet> [gateway]
NET+DGRP <group>
NET+DHCP 1
NET+ETH0?
NET+GATE?
NET+HOST <name>
NET+MAC0?
NET+PORT?
Boxer 4K Serial API Commands Technical Reference
020-101697-05 Rev. 1 (07-2017)
Copyright 2017 Christie Digital Systems USA Inc. All rights reserved.
©
Description
Sets the projector network settings as specified. (Saved
value)
Sets the device group name for the projector. (Saved
value)
This can help simplify broadcast searching by
organizing projectors into groups, particularly if a large
number of projectors are on the same local network.
Enables DHCP. To turn off DHCP support, switch to a
static IP by using the base command. (Saved value)
Returns the projector IP address. (Read-only)
Returns the projector gateway address. (Read-only)
Sets the name for the projector. With this set, devices
on the same network subnet as the projector can
connect to it using the name: <name>.local. (Saved
value)
Returns the MAC address of the Ethernet port. (Read-
only)
Returns the TCP port used for the Christie serial
protocol over Ethernet. (Read-only)
Serial API commands
Values
position = A numerical valuethat is subject
to the range returned in LVO?m
—
Values
All three arguments
are strings and the
gateway is optional.
—
—
—
—
—
—
1024 to 49151 (with
some exceptions)
40