Table of Contents
Advertisement
MWF–Manual Warp Filter
Manually corrects the distorted image.
Image distortion is caused by projection to a curved surface or by lens distortion.
Commands
Command
Description
MWF+HORZ
Adjusts the horizontal filter to correct image distortion.
MWF+VERT
Adjusts the vertical filter to correct image distortion.
NET–Network Setup
Modifies the network setup for this device.
Commands
Command
NET+DHCP <0 | 1>
NET+ETH0 "<value>"
NET+GATE "<value>"
NET+HOST "<value>"
NET+MAC0 "<value>"
NET+PDNS "<value>"
NET+RSET 1
NET+SDNS "<vale>"
NET+SETT 1
NET+SHOW <0 | 1>
NET+SUB0 "<value>"
Examples
Turn DHCP off:
(NET+DHCP 1)
Set the MAC address to 00:E0:47:01:02:3C:
(NET+MAC0 "00:E0:47:01:02:3C")
DWU1612-HS/DWU2022-HS Technical Reference–Serial Commands
020-103352-01 Rev. 1 (03-2020)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.
Description
Turns DHCP on or off.
Modifies Ethernet settings.
Modifies gateway settings.
Modifies the projector name.
Modifies the MAC address settings.
Modifies the primary DNS.
Returns the projector name, LAN IP address,
WLAN IP address, and SNMP settings to their
factory defaults. (Read-only)
Modifies the secondary DNS.
Applies the network settings.
Turns network messages on or off.
Modifies subnet mask settings.
Serial API commands
Values
0 to 9
Values
0 = Turns on DHCP
1 = Turns off DHCP
value = Ethernet address
value = Default gateway
value = Hostname
value = MAC address
value = Primary DNS
1
value = Secondary DNS
1
0 = Turns off network messages
1 = Turns on network messages
value = Subnet mask
49
Advertisement
Table of Contents
