Igmp Filter Set Command; Igmp Filter Profile Set Command; Figure 156 Igmp Filter Show Command Example; Figure 157 Igmp Filter Set Command Example - ZyXEL Communications IES-1248-51 User Manual

The following example displays which IGMP filter profile ADSL port 9 is using.

Figure 156 IGMP Filter Show Command Example

ras> switch igmpfilter show 9
port
--------------------------------------
9

44.3.2 IGMP Filter Set Command

Syntax:
ras> switch igmpfilter set [<port>|*] <name>
where
[<port>|*]
<name>
This command sets an ADSL port(s) to use an IGMP filter profile.
The following example sets ADSL port 9 to use the voice IGMP filter profile.

Figure 157 IGMP Filter Set Command Example

ras> switch igmpfilter set 9 voice

44.3.3 IGMP Filter Profile Set Command

Syntax:
ras> switch igmpfilter profile set <name> <index> <startip> <endip>
where
<name>
<index>
<startip>
Chapter 44 IGMP Commands
profile
DEFVAL
You can specify a single ADSL port <1> or all ADSL ports
=
<*>.
The name of an IGMP filter profile.
=
Specify a name to identify the IGMP filter profile (you cannot
=
change the name of the DEFVAL profile). You can use up to 31
ASCII characters; spaces are not allowed.
The number (1~16) to identify a multicast IP address range.
=
Type the starting multicast IP address for a range of multicast IP
=
addresses that you want to belong to the IGMP filter profile.
IES-1248-51 User's Guide
279