Comparison Of Parameters - Mitsubishi Electric MELSERVO-J3 Series Manual

Part 4: Replacement of MR-J3W-_B with MR-J4W2-_B

3.9 Comparison of Parameters

CAUTION
Never perform extreme adjustments and changes to the parameters, otherwisethe
operation may become unstable.
If fixed values are written in the digits of a parameter, do not change these values.
Do not change parameters for manufacturer setting.
Do not enter any setting value other than those specified for each parameter.
POINT
For the parameter converter function, see "Part 5: Common Reference Material".
The parameter whose symbol preceded by * can be validated with the following
conditions.
* : Turn off the power and then on again, or reset the controller after setting the
parameter.
**: Turn off the power and then on again after setting the parameter.
For details about parameter settings for replacement, see the MR-J4W2-_B
Servo Amplifier Instruction Manual.
Do not enter any setting value other than those specified for each parameter.
POINT
With MR-J4-_B_ the deceleration to a stop function is enabled by factory settings.
To disable the deceleration to a stop function, set [Pr.PA04] to "0 _ _ _ "
In cases of 11 kW or more, the dynamic brake (DB) needs to be assigned to a
device in [Pr.PD07] to [Pr. PD09]
4 - 14