Mitsubishi Electric MELSERVO-J3 Series Manual page 240

Part 5: Common Reference Material
Parameter
No.
Master-slave operation - Speed limit
PD32
adjusted value on slave
Note. For items that have no setting value listed in the table, see "Part 3: Review on Replacement of MR-J3-_B_ with MR-J4-_B_",
"Part 4: Review on Replacement of MR-J3W-_B_ with MR-J4W-_B_"..
(2) MR-J3W-_B => MR-J4W2-_B
Parameter
No.
PC01 Error excessive alarm level
PC03 Encoder output pulse selection
Note For items that have no setting value listed in the table, see " "Part 4: Review on Replacement of MR-J3W-_B with MR-J4W2-_B ".
Name Initial value
-
Name Initial value
-
-
Setting
value
Master-slave operation - Speed limit adjusted value on
slave
Use MR-J4-_B_ with the software version A8 or later to
-
use this function.
A parameter error will occur when MR-J4-_B_ with the
software version A7 or earlier is used.
Setting
value
Although the initial values of the MR-J3-_B_ and MR-J3W-
_B are different, the same operation is performed.
-
Also, the setting ranges are different. Check the setting
values and change them as necessary.
Although the initial values of the MR-J3-_B_ and MR-J3W-
_B are different, the values are overwritten with the setting
-
values on the controller side (parameter of MR-J3-_B_)
after power-on.
5 - 55
Description
Description