Mitsubishi Electric MELSERVO-J3 Series Manual page 113

Part 3: Review on Replacement of MR-J3-_B_ with MR-J4-_B_
No. Name and function
PA03 Absolute position detection system
This parameter is made valid when power is switched
off, then on after setting, or when the controller reset has
been performed.
This parameter cannot be used in the speed control
mode.
Set this parameter when using the absolute position
detection system in the position control mode.
0 0 0 x:
Selection of absolute position detection system
0: Used in incremental system
1: Used in absolute position detection system
PA04 Function selection A-1
This parameter is made valid when power is switched
off, then on after setting, or when the controller reset has
been performed.
The servo forced stop function is avoidable.
0 x 0 0:
Selection of servo forced stop
0: Valid (Forced stop (EM1) is used
1: Invalid (Forced stop (EM1) is not used.)
When not using the forced stop (EM1) of servo amplifier,
set the selection of servo forced stop to Invalid (_ _1_).
At this time, the forced stop (EM1) automatically turns on
inside the servo amplifier.
MR-J3-_B_
Initial
No.
value
0000h PA03
Same as MR-J3
Absolute position detection system
Set this parameter when using the absolute position
detection system.
The parameter is not available in the speed control mode
and torque control mode.
_ _ _ x:
Absolute position detection system selection
0: Disabled (used in incremental system)
1: Enabled (used in absolute position detection system)
_ _ x _ :
For manufacturer setting
_ x _ _ :
For manufacturer setting
x _ _ _ :
For manufacturer setting
0000h PA04
Same setting as MR-J3
Function selection A-1
This is used to select the forced stop input and forced
stop deceleration function.
_ _ _ x:
For manufacturer setting
_ _ x _ :
For manufacturer setting
_ x _ _ :
Servo forced stop selection
0: Enabled (The forced stop input EM2 or EM1 is used.)
1: Disabled (The forced stop input EM2 and EM1 are not
used.)
Refer to table 3.1 for details.
x _ _ _ :
Forced stop deceleration function selection
0: Forced stop deceleration function disabled (EM1)
2: Forced stop deceleration function enabled (EM2)
Refer to table 3.1 for details.
Table 3.1 Deceleration method
3 - 20
MR-J4-_B_
Name and function
Initial
value
0h
0h
0h
0h
0h
0h
0h
2h