For Your Information (Fyi; History (His; Intelligent Lens System (Ils - Christie CP2000-SB User Manual

Section 1: Introduction
B.2.2 For Your Information (FYI)
FYI messages are generated and broadcast when an overall change in the projector's status is detected. Each
FYI message identifies the IP address of the TPC generating the message, followed by a code for the change as
well as one or more parameters of descriptive details about what has changed.
NOTES: 1) Because FYI messages are gated by the Error Message Enable (EME) control, disabling serial
error message also disables FYI messages. 2) FYI messages do not occur unless there is a Cine-IPM present.
B.2.3 History (HIS)
A number of lamp histories are stored in memory, with the oldest discarded when there is no more room. An
accurate lamp history requires that the serial # for a new lamp be recorded when the lamp is installed. HIS
message parameters are:
• P1 = Lamp order (oldest lamp installed = 001, next oldest = 002, etc.)
• P2 = # of hours logged
• P3 = Lamp serial #
• P4 = # strikes
• P5 = Installation date & time
• P6 = Lamp type
• P7 = Status Failed to Strike
• P8 = Status Failed Restrike
• P9 = Status Unexpected Offs
• P10 = Life State
• P11 = Change Reason
B.2.4 Intelligent Lens System (ILS)
P1
0 = Installed
1 = Lens Reset on Startup
2 = Auto ILS
3 = Lens Calibrate
4 = Lens Reset
10 = Move All Motors
NOTE: This command
should be used to move all
motors at the same time. It is
more efficient then using
LHO (Lens Horizontal
Offset), LVO (Lens Vertical
Offset), FCS (Focus), and
ZOM (Zoom).
B-18
P2
0 = No, 1 = Yes
0 = No, 1 = Yes
0 = No, 1 = Yes
None
None
P2 = 'X' location
P3 = 'Y' location
P4 = 'Focus' location
P5 = 'Zoom' location
P6 = 'X' approach
P7 = 'Y' approach
P8 = 'Focus' approach
P9 = 'Zoom' approach
NOTE: Approach is optional. When no
approach is specified, a Negative to
Positive Approach is assumed.
-1 = Positive to Negative Approach
1 = Negative to Positive Approach
Return Value
0 = No, 1 = Yes
0 = No, 1 = Yes
0 = No, 1 = Yes
0 = Complete, non-zero indicates In Progress
0 = Complete, non-zero indicates In Progress
This is write only command.
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)