Adjust The Offset; Adjust The Offset With An Intelligent Lens System (Ils); Rotate The Integrator Rod; Align The Fold Mirror - Christie D4KLH60 Mirage 4KLH Installation Manual

Adjust the offset

• For the best optical performance and minimal keystone error, use offset and not aiming to
• Avoid extreme tilts or offsets. Corner vignettes on a white test pattern indicate extreme
1. Select a framing test pattern and adjust the horizontal and vertical offset to display a square
image on the screen with minimal projector aiming error.

Adjust the offset with an Intelligent Lens System (ILS)

• For the best optical performance and minimal keystone error, use offset and not aiming to
• Avoid extreme tilts or offsets. Corner vignettes on a white test pattern indicate extreme
1. Tap Menu > Advanced Setup > Lens Setup.
2. Verify the correct lens is selected.
3. Tap Enable Automatic ILS.
Modifying the offset now results in overwriting the pre-defined settings.
4. Tap the Test Patterns button and select a framing test pattern.
5. Tap Menu > Advanced Setup > ILS File Setup.
6. Tap the arrows in the Offset area.

Rotate the integrator rod

The integrator rod is aligned by Christie. If there are screen shadows, perform this procedure.
1. Unlock and open the optical access door.
2. Loosen the two screws (3 mm hex) securing the retaining clip to the rear of the integrator using
an allen key.
Use caution when removing these screws to avoid damaging the Remote Temperature Sensor
Module (RTSM).
3. Rotate the integrator rod to remove the shadow from the corners.
4. To focus the integrator rod, slide it forward and back.
5. Tighten the two retaining clip screws to secure the integrator rod.
6. Close and lock the optical access door.

Align the fold mirror

Align the fold mirror if a corner or edge of an image is missing.
1. Adjust the two screws located on the bottom front of the projector.
D4KLH60/Mirage 4KLH Installation Guide
020-101374-01 Rev. 1 (05-2014)
center the image in off-axis installations.
offset that should be avoided using mechanical alignment.
center the image in off-axis installations.
offset that should be avoided using mechanical alignment.
Adjust the Image
54