Removing And Installing Bottom B-Pillar Trim Panel - Skoda Rapid NH 2014 Workshop Manual

– Release screw for front seat belt -1- (40 Nm).
– Pull the seat belt through the opening in the trim panel.
– Remove the trim panel from the vehicle.
Installing
– The installation occurs in reverse order.
– After attaching the trim panel, ensure that the trim panel is
located in the double-braided strip of the door seal.
Note
Before the installation, check all the fixing elements for dam‐
♦
age, if necessary replace.
♦ On vehicles with seat belt height adjuster, ensure before fas‐
tening that the seat belt height adjuster is located at the shell
and the slider of the seat belt height adjuster is in the top po‐
sition at the trim panel.
After the installation has been performed, carry out a func‐
♦
tional test of the seat belt height adjuster.
Make sure that the seat belt is correctly positioned and has
♦
unobstructed movement.
3.5 Removing and installing bottom B-pillar
trim panel
Removing
– Run the seat belt -2- through the opening in the trim panel.
– Slacken the bottom trim panel -2- at the top end out of the
catch -1- in -direction of arrow A-.
– Slacken the bottom trim panel -2- at the bottom end out of the
catch -3- in -direction of arrow B-.
Rapid NH 2014 ➤ , Rapid Spaceback 2014 ➤
Body Work - Edition 10.2018
267
3. Trim panels of pillars