Wiring; Fuse Holder And Relay Carrier; Removing And Installing Fuse Holder From Dash Panel - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
97 –

Wiring

1

Fuse holder and relay carrier

Note
The exact assignment of the fuse holder and relay carrier can
♦
be taken from the valid current flow diagram ⇒ Current flow
diagrams, Electrical fault finding and Fitting locations.
Further information and description ⇒ Self-study programme
♦
No. 54 ; Škoda Octavia II introduction of vehicle .
⇒ "1.1 Removing and installing fuse holder from dash panel",
page 178
⇒ "1.2 Removing and installing the relay carrier under the vehicle
voltage control unit J519 - vehicles as of MY 09", page 179
⇒ "1.3 Removing and installing additional relay carrier above the
onboard supply control unit", page 180
⇒ "1.4 Removing and installing the E-box (relay and fuse carrier
in the engine compartment)", page 182
1.1 Removing and installing fuse holder
from dash panel
Removing
– Disconnect battery earth strap
– Insert the screwdriver in the recess -2-, lever out the side cover
-1- -arrow- and remove from the dash panel.
– Remove lower part of the dash panel insert on the driver's side
⇒ Body; Rep. gr. 70 Work.
178
Rep. gr.97 - Wiring
⇒ page 2 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�