Rapid NH 2014 ➤ , Rapid Spaceback 2014 ➤
Body Work - Edition 10.2018
– Install screws -3- (2.5 Nm) and -1- (1.5 Nm).
3.3.2
Removing and installing door sill panels
Note
The ambient temperature as well as the temperature of the
♦
parts must be at least 18 °C, maximum 30 °C.
After glueing the tuning parts, the vehicle must remain in a
♦
warm room for at least 24 hours.
Before glueing, all of the adhesive surfaces must be de‐
♦
greased with good quality - the quality of the glued joint de‐
pends upon this!
♦
Ensure thorough ventilation of the working area.
The adhesive surface of attachments must not be painted!
♦
Attachments can only be glued to the vehicle after thorough
♦
curing of the body paint.
Adhesive mate‐
Part number
rials
Glue sealing
Betalink K2
material
Activator
Betaprime 5600-1
Cleaning solu‐
Terostat 8550
tion
Applicator
D 009 500 25
182
Rep. gr.66 - Exterior equipment
Purpose, application range
Glue tuning parts to the body.
Prepare the surfaces before gluing to
improve adhesion.
For cleaning all surfaces to which
glass/paint primer and glue is applied.
For applying the activator.
Denomination, manufacturer,
comment
Observe the manufacturer
DOW's instructions.
DOW
Henkel