Head Airbag - Skoda Rapid NH 2014 Workshop Manual

WARNING
Switch on the ignition before connecting the battery. Improper
handling of pyrotechnic components may lead to unwanted
deployment after the battery has been connected. Nobody
should be inside the vehicle when the battery is being connec‐
ted.
– Work procedure for connecting the battery ⇒ Electrical sys‐
tem; Rep. gr. 27 ; Disconnecting and re-connecting the bat‐
tery .
Note
If the airbag control indicator - K75 - indicates a fault after as‐
sembly, the event memory must be queried ⇒ Vehicle diagnostic
tester.
3.17

Head airbag

3.17.1 Summary of components - head airbag
1 - Anti-twist protection line
❑ Used to protect against
twisting during installa‐
tion.
❑ It must be visible over
the entire length of the
airbag in the installed
condition.
2 - Head airbag
❑ On the driver's and front
passenger's side with
airbag igniter.
WARNING
Observe the safety in‐
structions for pyrotech‐
nic components
⇒ "3.3 Observe the gen‐
eral safety instructions
for working on airbag,
belt tensioner and bat‐
tery separation units (py‐
rotechnical compo‐
nents)", page 225 .
❑ Removing and installing
⇒ "3.17.2 Removing and
installing head airbag
with ignition for head air‐
bag driver's side/front
passenger side N251 /
N252 ", page 240
3 - Screw
❑ Always use a new screw
after disassembly.
Rapid NH 2014 ➤ , Rapid Spaceback 2014 ➤
Body Work - Edition 10.2018
239
3. Airbag