Skoda Rapid NH 2014 Workshop Manual page 35

1.6.2 Installing
– Clip the end part - 3 - of the Bowden cable - 2 - into the flap
lock (if it was removed) - arrow a -.
– Push the flap lock -1- into the lock carrier -arrow b-.
– Depending on the additional equipment, connect the plug con‐
nection for the contact switch of the engine hood.
– Tightening torque of screws -4- (12 Nm).
– Install the Bowden cable -2- in the Bowden cable coupling
⇒ "1.7 Separating the Bowden cable", page 28
– Adjust flap lock ⇒ "1.10.1 Adjusting the flap lock", page 33
• Before closing the front flap, carry out a functional test of the
operating lever and the Bowden cable.
Rapid NH 2014 ➤ , Rapid Spaceback 2014 ➤
Body Work - Edition 10.2018
.
.
27
1. Front flap