Preparing The New Window For Fitting - Skoda Rapid NH 2014 Workshop Manual

Rapid NH 2014 ➤ , Rapid Spaceback 2014 ➤
Body Work - Edition 10.2018
1.12

Preparing the new window for fitting

1.12.1 Cut back the adhesive bead
Carry out the following tasks
Note
Cut back the remaining glue sealing material to 1-2 mm just
♦
prior to adhering again. While doing so, do not damage the
glass/primer and ceramic layer.
The remainder of the sealing compound serves as a base for
♦
the newly applied adhesive sealant.
WARNING
Do not prime the adhesive surface and do not treat with clean‐
ing solution. Keep the adhesive surfaces free of dirt or grease.
Exception: If the bonding is not carried out immediately after cut‐
ting back, the sealing compound must be activated with the
activator.
1.12.2 Prepare new window for fitting
Carry out the following tasks
All the windows are not pre-layered as a spare part.
Note
The area where the adhesive bead is applied is neither pre-
♦
layered nor primed.
The sealing lip is a component part of a new windscreen.
♦
– Clean edge of the window (where glass/paint primer will be
applied) up to a width of approx. 20 mm with cleaning solution.
– Next, wipe off the edge of the window (where glass/paint pri‐
mer will be applied) using a dry, lint-free cloth not contamina‐
ted with any substances.
WARNING
The ceramic layer on the window is no glass/paint primer! It is
absolutely essential to prime it before applying the sealing ma‐
terial! Only use glass/paint primer D 009 200 02!
– Now apply the glass/paint primer with the applicator uniformly
in one go.
♦ Minimum hardening time approx. 10 minutes.
154
Rep. gr.64 - Glazing