Removing And Installing Cap For Lock Cylinder; Removing And Installing Lock Cylinder - Skoda Rapid NH 2014 Workshop Manual

2.4 Removing and installing cap for lock cyl‐
inder
2.4.1 Removing
Note
When removing the cap for the lock cylinder, do not turn or lever
the screwdriver.
Carry out the following tasks
– Detach door handle.
– Press a small screwdriver -3- slightly -arrow a- into the opening
on the bottom side of the cap for the lock cylinder.
– Slightly pull off the cap of the lock cylinder -1- , together with
the screwdriver, at the bottom side from the door -arrow b-.
– Slide the cap upwards from the lock cylinder.
2.4.2 Installing
Carry out the following tasks
– Remove door handle - 1 -.
– Place the cap of the lock cylinder -2- slightly angled from the
top -arrow a- onto the lock cylinder.
– Press the cap of the lock cylinder -2- onto the door -arrow b-,
until the cap with the lock cylinder locks into position.
2.5

Removing and installing lock cylinder

Note
A lock cylinder is installed only on the driver's door.
Rapid NH 2014 ➤ , Rapid Spaceback 2014 ➤
Body Work - Edition 10.2018
57
2. Door internal parts