Installing And Removing Sensor For Side Impact On The B-Pillar; Installing And Removing Sensor For Side Impact On The C-Pillar - Skoda Rapid NH 2014 Workshop Manual

Rapid NH 2014 ➤ , Rapid Spaceback 2014 ➤
Body Work - Edition 10.2018
– Select "Code control unit for airbag".
3.9 Installing and removing sensor for side
impact on the B-pillar
WARNING
Safety regulations should be observed during handling
⇒ "3.3 Observe the general safety instructions for working on
airbag, belt tensioner and battery separation units (pyrotech‐
nical components)", page 225
Removing
– Disconnect battery earth strap ⇒ Electrical System; Rep. gr.
27 .
– Remove bottom trim panel of B pillar
⇒ "3.5 Removing and installing bottom B-pillar trim panel",
page 267 .
– Unplug connector -3-.
– Remove the screw - 1 - (9 Nm) and remove the sensor - 2 -.
Installing
– The installation occurs in reverse order.
WARNING
Pay attention to the sequence when connecting the battery ⇒
Electrical System; Rep. gr. 27 .
3.10 Installing and removing sensor for side
impact on the C-pillar
WARNING
Safety regulations should be observed during handling
⇒ "3.3 Observe the general safety instructions for working on
airbag, belt tensioner and battery separation units (pyrotech‐
nical components)", page 225
Removing
– Disconnect battery earth strap ⇒ Electrical System; Rep. gr.
27 .
– Remove wheel house trim panel
⇒ "3.8.2 Removing and installing wheel house trim panel",
page 272 .
230
Rep. gr.69 - Passenger protection
.
.