Skoda Rapid NH 2014 Workshop Manual page 149

– Use the cutting tool BEA 000 001 to cut out the opening (di‐
ameter 18 mm).
– Use a step drill in order to drill the openings.
– First of all make the openings from the outer side of the bumper
when using a step drill. Complete the work step from the inner
side of the bumper.
– Trim the openings in a suitable manner in order to avoid dam‐
age to the paintwork.
– The glueing procedure of new sensor holders is described in
the workshop manual ⇒ Electrical System; Rep. gr. 94 .
– After installing the sensors, install the bumper
⇒ "2.1 Rear bumper", page 135
Rapid NH 2014 ➤ , Rapid Spaceback 2014 ➤
.
4. Cutting out the openings for the parking aid sensors (drill)
Body Work - Edition 10.2018
141