Rear Spoiler - Spaceback - Skoda Rapid NH 2014 Workshop Manual

Rapid NH 2014 ➤ , Rapid Spaceback 2014 ➤
Body Work - Edition 10.2018
Install the rear spoiler
Note
The ambient temperature must be above 18°C during the gluing procedure of the spoiler!
– Thoroughly clean the adhesive surfaces e.g. with cleaning
solution D 009 401 04.
– Apply glue sealing material D 172 090 A2 into the guiding
groove (Pos. 2) in the spoiler.
– Stick on the spoiler within 15 minutes after applying the glue
sealing material!
– Partially unglue the protective foil from the adhesive tape on
the edges.
– Position the spoiler evenly onto the tailgate.
– Maintain an equal gap of 2 mm from the side tailgate edge.
– Remove the protective foil from the adhesive tape.
– Press the spoiler evenly onto the tailgate.
– Secure spoiler against moving with adhesive tape.
Note
The adhesive cement must dry for 2 hours. Do not drive the vehicle in this time.
♦
Do not drive into the carwash within 24 hours of gluing on the spoiler.
♦
4.2

Rear spoiler - Spaceback

190
Rep. gr.66 - Exterior equipment