Rear Bumper Bracket And Runners - Skoda Rapid NH 2014 Workshop Manual

– Position the rear bumper with the assistance of a second me‐
chanic.
Note
When fitting the rear bumper, make sure to guide it parallel at the
left and right guide sections.
– Press the rear bumper onto the centre guide section and the
left and right guide section until they lock audibly together.
– Observe the parallelism and the correct gap sizes ⇒ Body Re‐
pairs; Rep. gr. 00; Rozměry spár karoserie; zadní část kar‐
oserie .
– Position screws and tighten
⇒ "2.1.1 Summary of components", page 135
2.2

Rear bumper bracket and runners

1 - Centre guide section
Removing
– Remove the rear bump‐
er
⇒ "2.1.2 Remove the
rear bumper",
page 136 .
– Release the nuts
⇒ Item 2 (page 137)
– Remove the bumper
bracket from the vehi‐
cle.
Installing
– The installation occurs
in reverse order.
2 - Nut
❑ Tightening torque - 2.2
Nm.
3 - Bumper bracket (depending
upon vehicle equipment)
Removing
– Remove the rear bump‐
er
⇒ "2.1.2 Remove the
rear bumper",
page 136 .
– Release the nuts
⇒ Item 4 (page 138)
– Remove the bumper
bracket from the vehi‐
cle.
Installing
– The installation occurs in reverse order.
.
.
.
Rapid NH 2014 ➤ , Rapid Spaceback 2014 ➤
Body Work - Edition 10.2018
137
2. Rear bumper