Skoda Rapid NH 2014 Workshop Manual page 59

Note
The arc outside the threaded plate must be firmly welded to the pillar. The lands to the threaded plate are
♦
malleable.
To adjust the locking clamp -2- once the screws -3- are loosened, increased force must be applied.
♦
Note
When closing the door it must lock completely without using
♦
additional force and must have no play.
When adjusting the locking clamp, the door must not be press‐
♦
ed upwards or downwards.
The locking clamp is used for adjusting the following:
• If the front door adjustment is not flush with the rear door or
the side part.
Carry out the following tasks
– Slacken the locking clamp -1- by loosening the screws -2- at
the B pillar.
– Adjust the door with the locking clamp -2- in such a way that
the front door when in the closed state is flush with the rear
door (wind noise).
– Tighten screws - 2 - of locking clamp - 1 -.
Tightening torque of screws -2- (20 Nm).
Rapid NH 2014 ➤ , Rapid Spaceback 2014 ➤
Body Work - Edition 10.2018
51
1. Front door