Removing And Installing Restoring Ring With Slip Ring; Removing And Installing Airbag Unit On The Passenger Side - Skoda Rapid NH 2014 Workshop Manual

– Disconnect plug connection -1- and if necessary -2- (only for
vehicles with multi-function steering wheel).
– Lay aside the airbag unit in such a way that the impact ab‐
sorber points upwards.
Installing
– The installation occurs in reverse order.
WARNING
Nobody should be in the vehicle when the battery is being con‐
nected.
Pay attention to the sequence when connecting the battery ⇒
Electrical System; Rep. gr. 27 .
Note
If the airbag control indicator - K75 - indicates a fault after as‐
sembly, the event memory must be queried ⇒ Vehicle diagnostic
tester.
3.14 Removing and installing restoring ring
with slip ring
– Removing and installing ⇒ Electrical System; Rep. gr. 94 ;
Steering column combination switch; removing and installing
restoring ring with slip ring in the steering column combination
switch .
3.15 Removing and installing airbag unit on
the passenger side
Removing
WARNING
♦ Observe the general safety instructions for working on air‐
bag, belt tensioner and battery separation units (pyrotech‐
nical components)
⇒ "3.3 Observe the general safety instructions for working
on airbag, belt tensioner and battery separation units (py‐
rotechnical components)", page 225
♦ Observe the special instructions for driver and front pas‐
senger airbag
⇒ "3.4 Special instructions for driver and front passenger
airbag", page 226
Carry out the following tasks
WARNING
When electrostatic discharges occur, there is a risk of the air‐
bag being activated unintentionally. Therefore, the mechanic
must discharge himself electrostatically before separating the
ignition and earth lead. This occurs, for example, by briefly
touching the body or the door closing mechanism.
.
.
Rapid NH 2014 ➤ , Rapid Spaceback 2014 ➤
Body Work - Edition 10.2018
235
3. Airbag