Removing And Installing Ignition Coils With Output Stage - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
1.6/81 kW MPI engine - Edition 06.2014
6 - Screw
❑ 8 Nm
7 - Hall sender - G40-
❑ removing and installing
8 - O-ring
9 - Screw
❑ 5 Nm
10 - Engine speed sender - G28-
❑ removing and installing
11 - Sealing flange on the gearbox side
❑ removing and installing
12 - Rotor
❑ for engine speed sender - G28-
❑ cannot be removed separately, only with sealing flange Pos. -11-
13 - Screw
❑ Tightening torque and tightening order
14 - Screw
❑ replace
❑ Tightening torque and tightening order
1.2 Removing and installing ignition coils
with output stage
Removing
– Remove air filter housing
– Separate plug connection -2-.
– Release screw -1-.
– Press extractor -T10530- up to the stop into the bore of the
ignition coils -1-.
– Tighten the nut -2- in -direction of arrow- so that the extractor
-T10530- stays firm in the bore of the ignition coil.
270
Rep. gr.28 - Ignition system
⇒ page 271
⇒ page 272
⇒ page 57
⇒ page 57
⇒ page 135
⇒ page 235 .