Setting The Correct Installation Position Of The Restoring Ring With Coil Spring - Skoda Octavia III 2013 Workshop Manual

– Pull out plug fuse -4-, push unlocking down and disconnect
plug connection -3-.
WARNING
Risk of destruction of electronic components by static dis‐
charge.
Prior to disconnecting the electrical plug connection the me‐
chanic must discharge electrostatic, for example by briefly
touching the door closure strut.
– Pull fuse -1- out downwards and press down and disconnect
plug connection -2-.
– Unlock and disconnect plug connections -1, 3, 4 and 8-, as
shown in the illustration. Use a screwdriver -6- to loosen the
plug connections -8- carefully out of the catch -7-.
– Unscrew screw -5-.
– Unlock retention clutches -2- -arrow- and steering column
electronics control unit - J527- from the switch unit on the
steering column.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Before pushing out the control unit on the switch unit the indi‐
cator lever must be in the 0 position and the ring rotor -3- must
be inserted in the correct installation position:
• The arrows -1- must be facing each other
• The coil spring -2- must be visible in the window between the
arrows -4-
Set the correct position if necessary
⇒ "8.5 Setting the correct installation position of the restoring ring
with coil spring", page 121
– Make sure that all the retaining lugs and plug connections lock
in place correctly.
8.5 Setting the correct installation position
of the restoring ring with coil spring
It is only carried out if there is a doubt about the correct setting of
the installation position for the restoring ring rotor.
Work procedure
– Put the front wheels in straight ahead position.
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
8. Steering column switch
121