Set The Scaler And The Frame Rate Converter; Set The Audio Streams - Lightware UBEX-PRO20-HDMI-F100 User Manual

 
     
4. Installation 4. Installation
4.8.8. Set the Scaler and the Frame Rate Converter
Set up the scaler and the frame rate converter (FRC) for the best user experience. The forced resolution and
refresh rate are recommended to fit the supported resolution / refresh rate of the sink device.
ATTENTION!
Both input and output
ports have FRC and CSC functions but
the scaler is available for the HDMI in
1 port of transmitter and HDMI out 1
ports of receiver and transceiver only.
Scaler - Example
In our example the sink device is a 4K-ready
monitor and we have to display a 4K60 Hz
video on it. The signal is transmitted on
the HDMI out 1 port of the UBEX receiver.
Navigate to the Crosspoint menu - Video tab
and select the Scaler panel on the receiver
side. Set the Scaling Mode setting to EDID
based which means the receiver read out
the EDID of the sink device and scaling
the image to that. In our example it is
3840x2160p60.Set the Image position to Fit,
the Color space conversion to YCbCr 4:4:4.
Frame Rate Converter - Example
In our example the other sink device is a
full HD monitor with 50 Hz refresh rate
and we have to display a 1080p60 Hz
video on that. The signal is transmitted on
the HDMI out 2 port of the UBEX receiver.
Navigate to the Crosspoint menu - Video tab
and select the FRC panel on the receiver
side. Set the Output resolution mode to
Forced resolution, the Forced resolution to
1920x1080p50, the Color space conversion
to RGB.

TIPS AND TRICKS: The stream and
the connected display device can be
identified by using the Identify Stream
/ Identify Display feature. It makes
generating 10 test colors on the display
device for 10 seconds.
series – Extender Application Mode – User's Manual series – Extender Application Mode – User's Manual
Applied F-series endpoint firmware package: v2.0.0 | Applied R-series endpoint firmware package: v2.0.0 | LDC software: v2.5.9b3
4.8.9. Set the Audio Streams
The audio crosspoint menu in the LDC software for an F110 TX-RX pair
Crosspoint Settings
Set up the audio crosspoint settings. Digital and analog audio source streams are also selectable in the case
of UBEX-PRO20-HDMI-F110 endpoint device. All audio streams can be selected to all outputs.
See more details about the audio crosspoint settings in LDC in the
ATTENTION!
The audio crosspoint settings always follow the source MUX settings of the video layer and
the MUX settings cannot be set in the audio layer.

DIFFERENCE: HBR audio formats are supported from LDC version v2.5.8b2 and endpoint firmware version
v2.0.0 only. If the embedded audio signal is HBR and an HBR audio not supported error message received
during the new crosspoint setting, please update the control software to the latest one. See more
information about the updating procedure in the
Analog Audio Settings
Set the volume and the balance for the analog audio input and output ports. You can also set the gain for
input port. The output can be muted or unmuted.
See more details about these settings in the
Audio Crosspoint Menu section.
Install and Update section.
Properties Windows - Audio Layer section.
49 49