The Total Number Of Horizontal Pixels; Horizontal Start Position - IDK MSD-701AMP User Manual

9.8.2 The total number of horizontal pixels

Menu Top→INPUT TIMING→H TOTAL PIXELS
Setting for IN6 and IN7
Setting value
Input signal
(Analog RGB/Analog YPbPr)
Interlaced signal
Non-interlaced signal
No input signal
You can set the total number of horizontal pixels of analog RGB/analog YPbPr input video.
The settable values vary depending on the sampling block (Horizontal sync frequency × the total number of
horizontal pixels) of input signal.
For other input signals, this menu cannot be set; only the total number of horizontal pixels is displayed on the
front display.

9.8.3 Horizontal start position

Menu Top→INPUT TIMING→H START POSITION
Setting for IN1 to IN7 for each input signal
Setting value 64DOT to 2900DOT (The total number of horizontal pixels - Horizontal active area or less)
[Default] Varies depending on the input signal.
You can set the horizontal start positions of input video.
If the set value exceeds the limitation mentioned below, the display start position will be set automatically to a
value within the parametric limitation.
The total number of horizontal pixels > Horizontal active area > Horizontal start position
If no signal is input, "NOT AVAILABLE NOW" will appear on the front display.
[Table 9.17] The total number of horizontal pixels
400DOT to 4125DOT
[Default] varies depending on the input signal
The sampling clock is within the range of 13 MHz to 81 MHz.
400DOT to 4125DOT
[Default] varies depending on the input signal
The sampling clock is within the range of 13 MHz to 162 MHz.
N/A
A message, "NOT AVAILABLE NOW" will appear on the front
display.
MSD-701AMP User Guide
Setting value
【See: 9.7.2 DVI input connector】
95