Input Image Capture - IDK MSD-701AMP User Manual

MSD-701AMP User Guide

9.19.8 Input image capture

Menu Top→BITMAP→CAPTURE VIDEO
Setting value
[Table 9.51] Setting input image capture
Setting item Setting value
*
Register number No.1 to No.4 [Default] No.1
*
Can be set if memory area is divided.
An input video can be treated as a bitmap by capturing and registering it. The maximum resolution is
[Horizontal resolution × Vertical resolution × 3 (the number of bytes per pixel; "3" fixed)] 8,388,608 bytes or
less. To register multiple bitmaps and captured images, the total resolution of all bitmaps and captured
images should be 8,388,608 bytes or less (aspect ratio does not matter).
Captured images can be displayed at native size or may be enlarged, but cannot be reduced in size.
Larger resolutions require a longer loading time; it may take approximately six seconds at a maximum.
Registered images having a lower resolution than the target sink device.
You can register any images having a lower resolution by setting output resolution to smaller resolution and
capturing the video.
To freeze the input video temporarily, press the "MENU/ENTER" button. To register the frozen image, select
"YES" and then press the "MENU/ENTER" button again. To release freeze, press the "BACK" button. It can
be released automatically when an input channel is switched or input signal changes.
If resolution of input video is too large compared to the reserved memory area, it can cause a significant
memory shortage. In this case, message "MEMORY SIZE OVER" will be displayed after you press the
"MENU/ENTER" button and registration will not be executed.
【See: 9.4.1 Output resolution】
【See: 9.19.7 Dividing memory area】
159